Comments on: CV Axles-Description and Replacement Info

By: Jeff Williams

Jeff Williams — Thu, 17 Nov 2011 14:17:52 +0000

Hi Joe. Thanks for the great comments. Jeff

By: Joe

Joe — Thu, 17 Nov 2011 03:48:02 +0000

$author Just checking out your blog. Looks Good!

By: Jeff Williams

Jeff Williams — Mon, 31 Oct 2011 13:28:00 +0000

Hi Jill, I dont think you could have driven your car hard enough to break off the inbound CV shaft inside the transmission. The shop that did the repairs should at least give you a 90 day warranty. If you can get a second opinion to see if they are telling you the truth. If the original shop continues to blame you for the damage then inform them that you will take them to court for it . You must have proof that it was due to there negligence . Jeff

By: Jill Maine

Jill Maine — Fri, 28 Oct 2011 21:39:03 +0000

I just had a 1993 Eagle talon worked on. They replaced clutch assembly and cv axles. After driving for 5 days the car wasn;t going anywhere. Mechanic tells me that the piece that goes into transmission on CV axle broke off into transmission. Says it was caused by rough driving. Which I drove it gingerly after having work doen. I think the poart was defective and they need to investigate. I should nmot be liable for this.

By: Jeff Williams

Jeff Williams — Tue, 11 Oct 2011 13:15:14 +0000

Thanks. Jeff

By: Dream Talk Recorder

Dream Talk Recorder — Fri, 07 Oct 2011 17:10:35 +0000

It’s good to see sites with quality information and thanks for the share that you’ve done. Usually, I’m quite surprised, but this material really has grabbed my attention.

By: Jeff Williams

Jeff Williams — Fri, 09 Sep 2011 13:25:02 +0000

Hi Josh, Thanks for the Great Comments. Jeff

By: Josh

Josh — Fri, 09 Sep 2011 07:04:36 +0000

Outstanding post! I would like to express gratitude just for this wonderful properly needed post. I’ll always be visiting
this site in future as well. I hope I\’m able to examine such great post throughout not too distant future

By: Pictures Blog

Pictures Blog — Sat, 12 Feb 2011 18:38:38 +0000

not bad!!! thanks!

By: chris m

chris m — Fri, 08 Oct 2010 14:35:42 +0000

jeff,

i have a 1990 acura integra ls with a jdm engine swap and im haveing some issues.when i got this car the driver cv axle was busted the tripod bearing came out of the inner boot and since i have had this car i have replaced motor mount on the driver side and the cv axle for the third time in the span of 3 weeks and still have the same issue with the cv axle and i cant figure out why it seems like the axle is too short.Is this a common issue with this type of project and how can i correct it